C32 ACERT™ (Water-Cooled Manifold) oil and ga

  • Minimum Rating 597 bkW800 BHP
  • Maximum Rating 914 bkW1225 BHP
  • Aspiration Turbocharged-Aftercooled

SPECIFICATIONS

  • Minimum Rating 597 bkW800 BHP
  • Maximum Rating 914 bkW1225 BHP
  • Aspiration Turbocharged-Aftercooled
  • Bore 145 mm5.7 in
  • Displacement 32.1 l1960.5 in³
  • Stroke 162 mm6.4 in
  • Length 1933 mm76.1 in
  • Width 1488 mm57 in
  • Height 1389 mm54.7 in
  • Emissions EPA and CARB Non-Road Mobile Tier 2, EPA Marine Tier 2, IMO Tier II, China Stage III
  • Flywheel And Flywheel Housing SAE No. 0 or SAE No. 1
  • Flywheel Teeth 136
  • Weight 2306 kg5084 lb
  • Industry oil-and-gas

EQUIPMENT

C32 ACERT™ (Water-Cooled Manifold) Standard Equipment

  • Air Inlet System
    • Connections configured for SCAC and ATAAC (Air-to-AirAftercooled) or remote heat exchanger
  • Control System
    • ADEM A4 electronic control module
    • Electronic governing, PTO speed control
    • Customer programmable ratings
    • Cold mode start strategy
    • Automatic altitude compensation
    • Automatic fuel temperature compensation
    • Programmable low and high idle
    • Electronic diagnostics and fault logging
    • Engine monitoring system
    • SAE J1939 broadcast (diagnostic and engine status)
  • Cooling System
    • Gear-driven centrifugal jacket water pump — RH
    • Integrated thermostat and housing
    • Engine oil cooler
    • Optional installed transmission oil cooler
    • Optional aftercooler and auxiliary water pump
    • Optional jacket water heat exchanger
  • Exhaust System
    • Exhaust manifold — watercooled
  • Fuel System
    • MEUI
    • Fuel priming pump
    • Fuel transfer pump
    • Primary and secondary fuel filter — RH configured for remote mounting (installed RH on shipping plate)
  • Flywheels and Flywheel Housing
    • SAE No. 0 or SAE No. 1 flywheel iron housing
    • SAE No. 0 or SAE No. 1 flywheel
    • Optional transmission adapter
  • Lube System
    • Crankcase breather
    • Oil filter — RH standard, optional LH or remote mount service
    • Oil level gauge — RH standard, optional LH or dual service
    • Oil filler — RH standard, optional LH or dual service
    • Shallow oil pan, rear sump
  • Mounting System
    • Trunnion front support
    • Vertical and horizontal pads on rear flywheel housing
  • Protection System
    • 24 volt electronic
    • Engine overspeed with optional air shut-offs with indicators
    • Low engine oil pressure
    • Fuel filter restriction
    • Fuel temperature
    • High engine coolant temperature
    • Low engine coolant temperature
  • General
    • Vibration damper
    • Lifting eyes
    • Optional customer wiring connector
    • Service tool connector
    • Paint — Cat yellow
    • Optional two-part primer and mastic caulk

C32 ACERT™ (Water-Cooled Manifold) Optional Equipment

  • Air Inlet System
    • Air cleaner
    • Air inlet adapters
    • Turbocharger outlet adapters
    • Air lines
  • Charging System
    • Battery chargers
    • Charging alternators
    • Alternator mounting
    • Circuit breakers and mountings
  • Cooling System
    • Dry charge coolant conditioners
    • Thermostat housing
    • Coolant level sensor
    • Radiator
    • Blower fans
    • Suction fans
    • Fan adapters
    • Fan drives
  • Emissions
    • IMO certifications
  • Exhaust System
    • Elbows
    • Mufflers
  • Fuel Systems
    • Electric fuel priming pump
  • Instrumentation
    • Customer management device
    • Interconnect harness
    • Gauges and instrument panels
  • Lube System
    • Oil pans
    • Oil service side
    • Oil level gauge
    • Oil filters
    • Lubricating oils
  • Mounting System
    • Structural steel base
    • Engine support — front
    • Engine support — rear
  • Power Take-Offs
    • Auxiliary drive
    • Damper pulley
    • Hydraulics gear pumps
  • Protection System
    • Mechanical shutoffs
    • Solenoid shutoffs
  • Starting System
    • Electric starting motors - 12V, 24V
    • Battery sets - 24V
    • Battery cable
    • Battery rack
    • Starting aids
  • Transmission Arrangement
    • Transmission water lines
    • Transmission cooler

RELATED PRODUCTS

CN1566 Electric Motor - Oil-and-gas

CN1566 Electric Motor

oil and gas

  • Electric Motor Type: Squirrel Cage Induction Motor
  • Full Load Speed: 1189 r/min1189 r/min
  • Mounting Designation: F1 or F2
Get a quote
CN3086 Electric Motor for Gas Compression - Oil-and-gas

CN3086 Electric Motor for Gas Compression

oil and gas

  • Electric Motor Type: Squirrel Cage Induction Motor
  • Full Load Speed: 892 r/min892 r/min
  • Mounting Designation: F1 or F2
Get a quote
CN3586 Electric Motor for Gas Compression - Oil-and-gas

CN3586 Electric Motor for Gas Compression

oil and gas

  • Electric Motor Type: Squirrel Cage Induction Motor
  • Full Load Speed: 894 rpm
  • Mounting Designation: F1 or F2
Get a quote
CN5086 Electric Motor - Oil-and-gas

CN5086 Electric Motor

oil and gas

  • Electric Motor Type: Squirrel Cage Induction Motor
  • Full Load Speed: 894 r/min894 r/min
  • Mounting Designation: F1 or F2
Get a quote
3406C - Oil-and-gas

3406C

oil and gas

  • Minimum Rating: 217 bkW292 BHP
  • Maximum Rating: 359 bkW482 BHP
  • Aspiration: Turbocharged Aftercooled
Get a quote
3412 - Oil-and-gas

3412

oil and gas

  • Minimum Rating: 476 bkW638 BHP
  • Maximum Rating: 551 bkW739 BHP
  • Aspiration: Turbocharged Aftercooled
Get a quote
3508 - Oil-and-gas

3508

oil and gas

  • Minimum Rating: 709 bkW950 BHP
  • Maximum Rating: 795 bkW1065 BHP
  • Aspiration: Turbocharged Aftercooled
Get a quote
3512 - Oil-and-gas

3512

oil and gas

  • Minimum Rating: 1066 bkW1430 BHP
  • Maximum Rating: 1195 bkW1600 BHP
  • Aspiration: Turbocharged Aftercooled
Get a quote
3516 - Oil-and-gas

3516

oil and gas

  • Minimum Rating: 1417 bkW1900 BHP
  • Maximum Rating: 1480 bkW1985 BHP
  • Aspiration: Turbocharged Aftercooled
Get a quote
Get a quote